Homemade Diy Free Standing Pull Up Bar

It is made from 2x4s 2x6s plywood and some iron pipe fittings.

Homemade diy free standing pull up bar.

Better yet find your studs and make your rig the right width to correspond with anchoring it to your studs behind the drywall. Cut two identical pieces of the 2 4 to the height at which you d like the bar to hang. The 90 degree elbow the 30 to 60 degree single socket tee and the three socket tee. Fittings used to build the pull up bar.

How to build a pull up bar. Ryobi nation diy pull up bar this diy pull up bar doesn t need a doorway and can serve as a work out station for additional exercises. 2 4 6 12 foot posts use treated lumber 1 4 foot 1 inch threaded pipe. The 90 degree elbow is used in places where the structure changes direction in a 90 degree turn.

Only do this if you know how to embed beefy drywall anchors. Use your wrench to tighten as needed. Insert one 90 degree elbow into each end of the long bar. 2 1 inch floor flanges.

This example is cut to 18 inches but it will vary depending on ceiling height and personal preference. Materials to build a diy pull up bar. If you face your drywall with wood and anchor it well up the wall it will provide a solid base for making a diy pull up bar at home. I was very carful to make sure that the structure was securely fastened to the wall to avoid injury.

These are dependent on the height of your garage ceiling and how you want to set up your pull up bar. 8 wood screws i got one pack of 14 screws and two packs of 12 screws nine total. The free standing pull up bar design utilizes just three different kee klamp fittings.